It is the pivot pins on each side they just fell out and the metal they was welded into is less than an 1/8" thick
I have a question, I am in need of a flapper door assembly that goes in front of the burn pot or try to make my own if the latter is the case I...
Thanks Ivanhoe
I need to replace my auger motor it is starting to get loud but I am not sure what RPM it is so don't know which one to purchase, can anyone help...
And where is the want/sell ad aera ?
I have a 4.5 rpm auger motor I had bought for my stove and it is just to much so if anyone is interested in it I will let it go.
ok will do thank you
where would a guy get the impeller upgrade ?
The corn I got is at 13% there is something that I cannot figure out, I see that some on here are running their unit on 3 or 4 if I tried to run...
where are you getting the stainless parts ?
Hello everyone got a quick question, I am trying to start to use corn because I can not find any pellets near me, but anyway can anyone give me...
no the screws are not touching, don't have a dealer went to the factory and picked it up, mark is on vac and matt was not in, will call tomorrow,...
It does but it is hanging up, cause if I take my hand and bump the unit it will move.
No one owner and is just 2 months old
Hello everyone, I was wondering if anyone has had a problem with the fan limit control, my unit is going well above 220 degrees before the fan...
I am heating around 2500 square feet and the furnace is in the basement and is hooked to the duct work from my gas furnace, the exhaust is coming...
Hello everyone I am new to this group and a new owner of the 50f furnaces, got mine on the 16th of november and installed as an addon, not doing...
