[ATTACH] I bought this pellet stove off of Kijiji. Guessing I’d say it may have 6 bags of pellets thru it. It’s a nice looking stove, just waiting...
I am looking at buying an Enviro P30. They seem to have decent reviews, is there anything I should be concerned about. Thanks
K, so I pay 250$ per metric tonne (2200 lbs) CDN. So I would say I'm getting a good price on pellets. But I have to buy 3 tonne minimum.
I got the new board you recommended. Install and the furnace works perfect. Only had 1 issue, the igniter would not work. So I lite it manual....
Is -05888 the board number? And where is a good place to get one?
Grrrrrrr. So I put the board back in and tried to start it back up. Had no luck. I put it to "test" mode and the combustion fan ramps up and down...
K, so my dips are not correct. I have a black wire to my ESP. I have a finned igniter. So, should all my dips be on "0ff"?
How would i know if my board should take a red ESP or a black ESP. The electronics man said the board I have is not that old. And I'm looking to...
Neither. I went home and did an inspection of the igniter and I replaced the igniter to be safe with a new one. I may install a circuit breaker on...
So here is the update. I am actually a millwright in a mill. So I asked my co-worker who is a good electrician to have a look at the board. In two...
I’d say you are exactly right. When I got this furnace he had a timer on it for the fuel auger, and I belieave it was wired wrong. Can I replace...
I have an amazing heat pellet boiler to give away. 165 BTU I made a deal to pull it out of a basement of friends house for a trade. It pressure...
No, the status light stays solid. The igniter light never goes off, and I checked it with pin tester and shows still sending power. The auger will...
Hey. So I did some work and got the igniter running. The fire light and away it went. But it's not working right, the auger is still running even...
Yes, harmen thermostate. Room temp of 75
The status light was solid, did not blink. I did a manual light as the igniter is not working great. Yes I am using a wall mount thermostate....
Ya, the furnace worked before. The light cycles off and on, but the auger keeps running. the furnace was connected, and no to the surge protector.
So, I fired up the pellet furnace today, and the feeder auger won't cycle? What is my issue? It comes on and will not shut off, so after about 10...
Yep, it’s bent just a little there. Think I might have bent it in the vise when I cut the old plate out. Small job, I’ll straighten her out.!!!!...
