I have a similar setup as Jason The Wood Wolverine I just bought a new set of breaker and spinner. Mine is set up on a 2x4” that clamps into the...
Thank you!
Just got done rebuilding this one. Swapped out the bottom end, as the cases were cracked, and I had complete bottom end sitting around. Hit it...
Any time! They’re very well built saws, and simple to work on. The guys at The Cutting Edge in NY may have some parts, but I know they’re...
Thats an awesome find! No spark is pretty common on the PS-9000. Coils were notorious for going bad. I have a PS-9000 that still runs on the...
That’s exactly the one I’m thinking about too. I could swear I saved it too, but I can’t find it, and I can’t find it online.
No, this was an actual competition sponsored by Oregon to see who could make the best cutting chain from an off the roll loop. I think it was...
I’ve worked with bicycles for a long time, and almost all we use for polishing the bikes up after service is Pledge. We’ve used for the last 15...
I read that article a while back, and I’ve tried finding it again, but no luck. It’s a pretty interesting read. If you’re into that sorta thing......
Does the impeller turn, or just the augers? I’ve had impeller shear pins break in the past, if there’s very wet and heavy snow. Should be a quick...
I had a little CS-310 a while back. Was a fine little saw. I used it for yard clean up and small stuff. If I was going to do it again I’d get the...
Thank you!!
I have to agree with everyone saying get the biggest you can comfortably afford. You’ll never go “This just blows way too much air”. Lol I have...
The cutter marked 2 is a little less aggressive and would probably stay sharp a little longer, but still has enough forward lean to feed well. I’d...
Same dresser angles, but the holder is moved one notch back. Changed the top plate to 25 degrees. [ATTACH] [ATTACH] [ATTACH]
Stock grind on a new Oregon 72CL chain. Top plate angle is at approximately 22 degrees. The top plate is hard to measure correctly as they all...
chris The other thing I did was take the bearing out and grease it up. It’s way smoother and swings effortlessly after that.
Sounds good. I usually run mine at the same heights as yours. Maybe even a touch lower. My .030 guide is what I use the most.
chris I put these wing nuts on my swing arm travel limiters. That way I can lock them down, and not worry about them moving. I am, like you, new...