Hmmm..no water..... I wonder if I could cut clean out openings and make covers.... the 20-2 has them.....
Lol Bob...next time you're in Central MA a beer it is. Smokey....lol I was thinking of sand. Profile 30 down stairs is next....on a vent (20...
Stove has been running nearly perfect all weekend. Leave blower suck, shop vac blow, and rubber mallet did the trick. Pellets fill to about 30%...
Yes.. burning very well. I actually closed the damper just a little....it lights about a minute quicker ... I'll let you know how it runs over...
Burns like this once the start load is done...
Yep
Yes...new auger motor
The pictures are of the startup
I had to move the stove outside to do this.... Did you notice in the pic that the burn pot is full to the top.... I have the auger as low as I...
OK.... the photo eye by-pass was outlined on this site. Works well...ran out of pellets last night and did fault and shut down. The openings are...
Oval is an optical illusion.... little bit of ash making it look oval.
Deck clean ports... open during the photo. Allows ash to be swept into ash bin below. Closed during operation.
Weld lines
I'll give it a try, thanks :salute:
Thanks Mike, just replaced it. 2nd one in four years. The lighter won't screw in more than two turns, the first one was the same. It gets tight...
There's two screws on each side.... they hold the brackets that holds the firebrick up. There is one of those on each side that held up a flame...
Just double checked my profile 20 ..... no clean-out panels. Lol even took a photo. This stove is a profile 20 not a profile 20-2. I have the...
So far I have: replaced the exhaust fan (spring) Done the photo eye "by-pass" Replaced the "fire brick" (found no clean-out ports) (this must be...
About 5 minutes.
About 5 min.
