You are asking alot of that little stove especially with zero insulation. If you were fully insulated and programmed the board to run on mode C...
What pellet stove did you buy and what pellets did you try?
I can toss in a pic of an ugly useless burl. White cedar. Its been sitting on the shelf for 3 years. Customers think its cool but nobody wants...
Im about 5 hours north east of cortland.
Depends on how badly you want one and how much you are willing to pay for it. If you take good measurements and draw up what you want, about any...
I know for a fact my old stove would need to be ran thru the startup procedure a quite a few times at that temperature. Sometimes had to restart...
-17 here right now on the NE tip of New York. Stove is deffinately getting a work out.
Yup. The fan speed is tied to the heat setting.
Sorry i read too much on here to take that seriously ;-)
Considering i had to completely remove the complete vent and wall thimble. He actually started to try and take the thimble off the wall as i stood...
Not everbody watches over the hired shoulder to see how its being done.
Im pretty sure its the same pipe you have.. i read an old post where you had problems getting the right parts. BDM biovent... expensive too for...
So far i am pretty happy with it other than the issue of not being able to adjust the convection blower. It does need a new control board cover...
Technically, the correct way is to cut the square out of the siding so the thimble sits against the sheathing and trim it with j channel just as...
I wasnt even going too mention this but may as well... the screws for the thimble and the vent bracket were installed into vinyl siding only.
Its a 2008 enviro evolution (ef5) Other than needing a cleaning its been burning beautiful for 2 weeks now. $300.00 for everything.. i couldnt...
The appliance adapter and the elbow are black vs grey but they are the same brand. And considering the dog and 3 cats i cleaned out from the...
I am amazed at what little it takes for some to be considered professionals. I recently purchased a used stove and all venting from someone and...
Basically that shiny piece of metal you see above the air intake is the back side of the exchange. Folded nicely around the sides and the top....
I would normally agree with you on that. I had asked the question at first elsewhere "if it was designed to cool the exhaust" But i think...
