Problem solved, the new motor had a separate ground, and I found a wiring diagram where they swaped a couple wires!
I ordered from Stove parts the first time and was very pleased! This time I ordered from Moutain Hearth products and the first one was damaged...
It’s been 7 years since we replaced it and the bearings finally have had enough! Ordered the non oem one. The new one has about a foot of cord...
Thank you all for your suggestions! While trying to vacuum it out again this time with a small section of garden hose taped to the shop vac it...
I thought about that but there is 2 gaskets and a tube of silicone holding that lol! The stove shop had a heck of a time getting it sealed years ago!
Getting the stove clean and ready for winter I pulled the motor and was brushing out the ash. I then always use the air compressor to blow it...
Ty Eaton appreciate it! Hard to tell from your picture but it looks like your flame is a lot higher on setting 2. My feed and combustion are...
Ty I appreciate it no rush I know the temps are warm. I have the heat pump on tonight no use burning fuel with these warmer temps! Hope you had...
I have not been around much with all the medical stuff going on. I go to the hospital 3 days a week for iv treatment and I start rehab in a few...
I have burned through a bag of Virginia Goldens last night. They burned great decent heat low ash no clinkers. I am now burning the Green...
If you get a minute would you mind posting a picture of your flame on setting 2 since we have the same stove. I got a error code 3 Monday,...
Stopped at Lowe’s they have golden pellets 247.00 a ton. They also have a Lowe’s brand I have never heard of. The goldens are a softwood blend....
Anyone burn Green Supremes this year. I am a lignetics person but am about out. Called my local Tsc and they have the Greens for 212.00 a ton....
Hey all, I know this thread has been going in forever, I just wanted to thank everyone again for there help. The new motor is up and running...
I called Ebmpapst and they advised me that motor is proprietary and can only be sold to Sherwood industries. I think at this point I will just...
Hey all I am back and want to first of all ty for the above post with the disassembly instructions. With that said unfortunately I am layed up...
I cannot tell you how much I appreciate everyone here, I have no problem admitting if I do not know something. I have never taken a motor apart...
That’s awesome, I appreciate you sharing the recipe!
My motor has a shaft coming out that goes into the squirrel cage held in place by a set screw! The only bearing we saw was on the opposite end...
I have burned the green label lignetics for years and love them, are those the ones you had a negative experience with! The TSC throw good heat,...
