I had a similar issue. The top plate would stick and overflowed with pellets since it couldn't retract. I ended up buying a new burn pot assembly...
My fantec damper did the same thing. I don't think they're designed for the heat produced. I got a new back draft damper from Fahrenheit.
I had it done by the same company that installed my geo unit. It's like a metallic bubble wrap.
So my furnace is currently running on level 4. Hot air temp is running between 148 to 152 degrees. Here is a photo of the temp probe in the duct...
Should I keep the damper wide open, or back it down to the set screw? Any negative affect with keeping it wide open? Thanks!
Here is the flame on level 3 with the damper fully open. This is after I updated the sail switch, exhaust manifold, and blower. Dropbox -...
Do you have a booster fan in your duct or do you find the 800cfm fan sufficient?
That's surprising. Matt from Fahrenheit made it seem that all led panels were being recalled.
Thanks for the help. I'm looking into getting an updated sail switch, exhaust manifold, and exhaust blower.
I was running on t stat mode level 4. This is with the damper set to about half open with the set screw.
Here's a quick video on what my burn pot looks like after running nonstop for three days. Is this normal? Seems like a lot of spillover on either...
I removed the OAK. Here's a video of it burning at level 3 with the damper wide open....
There is a plastic cap at the end of the OAK. Should I just remove the OAK and have it pull air from the basement?
Do you have links to where I can purchase the bigger impeller, exhaust manifold, and sail switch? Your flame definitely looks more violent than mine.
My video was right after the flame stabilized, so there wasn't a coal bed. Is the damper on the back, the only way to tune the furnace? Where do...
Here is a link to the video of it running at level 3 with the damper fully open. Dropbox - 2016-01-10 17.11.15.mp4
Here are some photos. [IMG] [IMG][IMG] [IMG] [IMG]
Working on taking some photos. I shut down the system last night so I can inspect and clean it today. I was running on t stat mode level 4. Should...
Serial number is 2566. It was an led control panel but it was replaced with an lcd due to the recall.
Hey everyone. I finally got mine up and running. Its been running for the last three days, but it seems to need some tuning. There's some soot...
