Thought I would post up a picture, I was shoveling the back deck again! This snow in New England just seems to keep coming. The first time I've...
I put one on my small Lopi, one more thing to experiment with. It works great the first few hours, during the hot part of the burn. Close her...
Twenty inch east west for the IS for me and a two by eighteen limb north south on the side. I would definitely do twenty two but have 32 cords cut...
I am about 2 1/2 weeks into burning my IS, still running with the damper closed for the entire burn once the cat's lit. I did start to notice a...
There's a guy not to far from me, a nice guy, a wood processor selling kiln dried, a good sized operation. Using an OWB to kiln dry, operates...
Glad to have the drama in the past to. One of the reasons I picked this stove was this thread.
Once again I refuse to go into whatever controversy you seem to think exists. I have never said anything negative about you so just drop it.
I haven't the slightest clue what you seem to be reading in to my posts but let me assure you its not there. Its all about the stove.
Wow, relax
The actual question in the post was whether the earlier ideal's seem to need more attention to detail. Where mine seems to be set and forget for...
After following the posts on here, there seems to be quite a bit of experimentation going on as to loading techniques. Different setups for...
I was wondering what temps you are normally running at, and measured where? When was your stove put into use? just wondering, I am just starting...
Thought I would post this up for any of you purchasing a new stove from Woodstock. I haven't seen this posted yet. When I called them about some...
I did do a moisture measure measurement with a harbor freight meter yesterday split 4 pieces got 10% to 15%. I do wonder if the 8" pipe makes a...
I don't think I am quite understanding your explanation. So will you be modulating the air input slide plate like you would in most process...
Okay I have it there now, going to check it out thanks, I have been putting the little pieces of kindling on the right side seem to light off there.
So I am guessing you would be using a linear actuator /servo on the primary/secondary air, the only variable there seems to be to control. It will...
Do you mean on the front of the stove on the opposite side of the cat port where it is now in my picture? If I open her up it will drive me out...
Hi Brian, started my career in aerospace and mil spec back in the late 70's, relay logic and L+N paper recorders back then, then onto the early...
Yeah it takes right off okay, haven't stalled it yet I think, my first cat stove so just following Woodstock's info.
