Is there a current active code available for 2025?
Trilifter7 I think if you are looking for similar contrast you might go with blk and silver color combination.
"Pulled the trigger" I hear ya, welcome to the club. [ATTACH] [ATTACH]
Give it a fluff I think you will be happy with the result.
The door gasket is quite thick you can fluff it up by squeezing it togather and achieve an almost new seal without messing with the handle.
For anyone interested, I found the data graphs with and without the radiator modification. Oct 26-27 2016 [ATTACH] [ATTACH]
Somewhere in this thread I posted two burn graphs one with and one without the mod. There is a noticeable difference with the mod installed.
Cheap stuff, nothing fancy. Clearance above the radiator is tight[ATTACH] so I stayed away from anything sitting on top.
Here is my version. [ATTACH] [ATTACH] [ATTACH]
Pull the trigger you won't be dissapointed! [ATTACH]
"I usually engage cat @500-600 degrees on the probe, temp rose above that while I was in kitchen. It's been that high (800) before prior to cat...
Pretty much every night the magnetic thermometer demagnatizes and falls to where it is in this pic. It starts out with the center hole even with...
This is how I load my stove. Fill halfway to the frt and all the way to the secondary plate, light 1/4 piece of a super cedar and fill the...
This is a pic of how my catalyst probe is positioned. In a black box when I load it I see temps of 1500° with stove top at 600° or less. I have...
They do say that the catalyst will start to burn at 500° smoke temp but the reccomendation for cat engagement is for a surface temp of 250°. If...
The majority of the flame was on the opposite side of where my probe is located and at that point the majority of the heat is heading up and out...
Just hit my target temp of 600° flue here are what all my temps are. Cat. ................ Flue Fire box. ............... Stove top[ATTACH] Cat...
Do you have a thermometer on the stove top? It should have come with one. They are relatively accurate. I would play with its placment to find...
Are you engaging at 500° on the cat probe? If you are that's too low of a temp. Minimum surface (near top fue exit) temp for engaging is 250-275....
I only load east/west. I rake the majority ash into the pan then the remainder is taken off the grate and piled along the sides of the grate...
