I have done this a few times, a couple of tractors and machine tools. Get some blocks to keep it off the ground. Jack it up, place a large tarp...
Did you use a oil or water based sealer?
This one is a 18" blade, 7 1/2 hp and it is 3 phase.
I have had good luck with them, quite a few purchases. 2+ hour drive one way for me so I was hoping to find someone close to them. I figured it...
I think she was referring to two different pieces of equipment....
Looking for someone to go to the Wisconsin Surplus auction house and take a look at a radial arm saw that is on the block. Willing to pay for the...
I hate sap and try hard to avoid it. Never fails I get it all over me, my hair, glasses just everywhere.
Ouch! Could always have been worse. Saw the aftermath of something like that but the battery shorted out and caused a fire.
Is that a shovel handle on the stater?
I'd like to have a trailer like that! Build a little deck on top, maybe a camper??
Naw....... He was too nice.
It would become a hobby of mine just effing with the guy.
You can probably just push it in, with the line disconnected, and be good to go.
Be careful you don't damage the rod in any way. I know that the oil is expensive but it's still cheaper than fixing the system. After the repair...
What about plastic? I was thinking about something UV resistant and putting counter bored holes for the clamp pads on the motor to sit in. My boat...
Glad you said that....I was thinking about using it on my boat.
The tank is the axle and is 4"x6"x1/4" tube. The plug is straight thread hollow and aluminum with around a .2" side hole. The filter is exposed...
Someone borrowed my speeco and damaged the filter. New filter and over filed. The threaded vent plug blew out and was never found.
Ram needs to be RETRACTED when filling the reservoir to the full level.
I agree, go get it and figure out what to do with it later.