I haven't yet checked the chimney for creosote, but I can't imagine it's loading up a lot. Everything is burning nice and I can run it at lower...
a dirty water pump, a Poulan / Craftsman saw, and a Husky in a box... And way over in the corner is the missing circlip that sprung out of the...
I'm right there with you on getting out from under trees with dead limbs. Lots of times I'll put a bull rope up and cut till it's almost ready to...
I reloaded the stove with a full load of Cherry, Ash, Sugar Maple this time at 7 hours after this mornings load. Flue temp was at 200* and there...
4 hours into the burn from post #89 above. I raked the coals to the front, flue temp is just under 300* and went to a little over 300* five...
3 hours into the burn from post #89 above. Secondary flames are out. Mostly coals and charcoal at this point. flue temp is just under 300*. I...
+++++++++++ +++++++++++++++++++ No visible smoke No noticeable smell downwind A little visible heat ripple Flue temp at wall thimble above the...
So far, so good. Put in a full load this morning and let it get up to 600 then closed the primary air. At 1 hour into the burn, the baro damper...
We've had a couple days and nights of unseasonably warm weather. With the barometric damper in place it has reduced the draft SIGNIFICANTLY on...
Did that happen while running and suck your coverall in? Or while starting?
Glad you were able to figure that one out... Carb issues are always a bear... unless they aren't... :doh:
I'll keep an eye on this aspect of the install as well. I do have a chimney brush and can easily clean my chimney out side from the ground....
Well said. I'm not really interested in spending money at this point on a meter. I'm not planning on going around checking chimneys. I did the...
I had to adjust the weight on the baro a couple of times to get the draft down to where closing down the stove controls would maintain a full load...
Had some time this morning and afternoon before going to a couple parties this evening, so I was able to get the barometric damper installed....
It's here!!! Now I have to get to it... Seems built well and doesn't stick open or closed. Rubbing or getting stuck in one position is the main...
short video of the burn. door is sooting up, secondaries are cranking, and it's throwing out some serious heat for the furnace fan to capture and...
The barometric damper should get here later today. I may be able to install it Sunday, but not sure yet. I think I have all the other parts on...
I picked up the rest of the stuff I need to install the baro damper this evening. When the baro gets here I'll wait till a little warmer day to...
I ordered one. I've seen other reviews of the cheaper ones that screamed "RUN AWAY"... It ended up less expensive than in the add. Also it...
