Yesterday was CLEAN THE STOVES DAY.... Did a good cleaning and LBT on both stoves. Been too long on the big stove and the performance was showing...
Pine is a good wood for pellets..... We had a few tons of Heartland pine pellets some years back.....they burned really well. Pine fir mix....no...
So many pellet producers scrape up every morsel of wood they can get. In doing so the incidence of Clinker forming materials is common in some...
The shells do leave a lot of ash....and they are a bit of a pain to get them to slide down most hopper slopes. In the regular pellet stoves the...
I knew that US stove bought out Gary Wisener... We finally found a shop that sells/has sold them and went to have a peek at the little devil....
Still beating on this Wiseway install. The Mfg's can't seem to tell me if the routing I need to use to get this bad boy set up will work right.....
Yes A failing/ as in too heavy of an amp draw.....can ruin a board. An Auger that is bound up with pellets, has a stiff, dry set of...
Yes. The POF light sensors were a nightmare.....Far too many false shutdowns due to dirty sensors. A lot of the optical sensors were are...
Shell runs complete. Two loads and 20 barrels full. Just finished putting the outfit away..... Gotta go haul all the barrels into the barn...
Busy day yesterday and today is gonna be more of the same.... Weather is fabulous until late Thursday....then the wet returns. Maybe some snow...
Sometimes ya just have to do what ya gotta do. Here is my big Whitfield which is just to the Right of where the new stove is going. I used a 2"...
That is the one thing I like about steel....JUST WELD IT BACK ON..:yes: I got a good shot of dry weather this morning and welded the pad frame up....
Weather was off and on yesterday with some dry slots.... I managed to get the 3/4" plywood base trimmed up to the actual size I wanted....since...
They don't make them like that iron horse any more......Built really well.
Made another trip to the Depot and bought a couple tiles. Drove home and tossed them on the floor...Yeah buddy. Drove back down and grabbed 3...
I agree 100% on that idea CF. Should not be an issue....Buttttttttttttttttttttttttttttttttttttttt.... I am not sure how hot that pipe is gonna...
Thanks B It is close....but my camera lies some too :rofl: :lol: It is a slightly different shade.....less gloss to the finish than the vinyl...
Yes...Natural draft. Book says either 3" or 4" pellet vent (Lvent pellet pipe) I called the factory and varified things too....just to be dammed...
Spent yesterday doing more MUCH NEEDED cleaning, measuring and room rearranging so we can get started on installing the Wiseway pellet stove....
Most of the pellets we see here are Doug fir. The Shells make a fair amount of ash. I am not really concerned with using shells in this...