milw saw, I have a couple of questions for you about the atmos if you don't mind. There are 2 dials on the front of the unit. One is the...
I considered the same thing. We can get a $400 credit for installing one around here so that knocks it down to $600 and is one of the few things...
Can I ask how many people are in your house? I'm thinking of doing the same for the summer months and am curious how far my 660 gallons will get me.
Having a wood stove on each end of the room sure would make my wife happy!
I agree 100%. If they treat the stuff they are keeping like it's junk they most likely treat the stuff they are offing the same way or worse....
My thought on leaving power equipment outside is if you let it live outside it slowly turns into the outside and rots away. That saw sat outside...
I would let him keep the saw right along with the dogs if I was you.
To be fair, they had many go through that had proper oil changes with the cabs and heads off. Ford really f'd up those motors and cured me of...
Just wait until every 'polar vortex' starts getting a name. The weather channel blows.
I didn't do anything with diffusers. We'll see how it goes. I am, however, going in from bottom right of tank one, out top left of that tank and...
Or better yet use boiler exit temp. If the boiler exit temp is above 185 (or whatever) then open the storage tank zone valve for 30 seconds to...
Coal Reaper, Adding a second port is out of the question at this point, at least this year. This did, however, occur to me. I am using a micro...
Made a cart to drive the tanks up like a trailer [ATTACH] Drove it up the the sliding door and into the house [ATTACH] [ATTACH] Stacked the...
See below. When the wood boiler is up to temp and no zones are calling for heat the tanks will be charging from top down, reverse through the...
They are going into the boiler room of the house. My garage is a couple hundred feet away and down hill so I am going to stack them once in the...
I made a template for cutting my chimneys through the wall and drilled around from both sides. It made for nice clean holes through the block...
Yes!! And as we all know, happy pregnant wife=husband free to work on his projects.
Sorry for not updating lately. A couple of projects popped up and slowed me down. On the plus side the little girl has a new to us playground...
I hope I will be up and burning by the end of November. I took a little time off the project to put up a playground for my daughter but that is...
I'm guessing the wheel bearings from a pickup will hold up just fine. There has to bee way more side load on a spindle attached to a 3 ton pickup...
