Well, all three of the Solo saws share the same bottom ends, I'm guessing that the Dolkitas do too. Check your IPLs for part numbers.
Courtesy of Al Smith Here are the order numbers from McMaster Carr for the holders for scotch brite! Aha and so it is ."Disc holder " Mac master...
I agree, that is why so many of them went to saw racers on the west coast. One guy took two to make a 4 cube and a 5!
Just got a message out of Germany a few minutes ago, C/P kits are stupid expensive $260.00 to me. I think this is a bust!
Don't forget to order the metalized base gasket and the piston pin bearing. Make sure you get the metalized base gasket for the 7900 the paper...
Fuzz: given the price Jon1270 got, it would be crazy not to go OEM! Perhaps he will share his source with you via PM.
Had a little time at the end of the day, so knife edged the transfer port entrys.
6) Get yourself a copy of the Dolmar 6400/7300/7900 workshop manual and buy a good T-27 T-handle and a long T-27 3/8 socket!
1) Online source for the HD air kit http://www.edgeandengine.com/ or you can call Nathaniel Vansickle@(740) 255-7674, Nate is a Dolmar dealer in...
If only mild aluminum transfer I dilute the acid with water then Wiggs, if carbon tracking I use Wiggs method. If there are visable defects like...
I have used all the above methods. For me it depends on what thecustomer wants within his:her budget. With acid a little heat helps. With Wiggs...
OK, still have one left! So, if it does not go in the next couple of days, I'm going to put a 681 top end on it, have it ported by Randy Evans and...
well, when you figure out that there are almost 100 screws of various sizes in the saw at an average of $1.34 each, you can see how fast it mounts...
There will be some used parts probably oil pump, coil and flywheel. Rest are new. If I have good used I cannot see running the cost up by using...
OK, some progress made: Installed new crankshaft Buttoned up the case with new gasket and torqed case bolts New seal installed Flywheel side...
I have a 362XP with a small mount Sugihara bar, the bars are great but I find that the light bar on a heavier saw sort of puts the thing out of...
OBTW, I will remove the limiter tabs on the 12-1(B) carb but retain the caps. On the RWJ-4 you will need a splined carb tool. There are limiters...
Terry has a good point, however this is a membership designed saw, so I will build what ever the members select.
Kevin, you can see the 'World Champion' top cover and starter cover in the first picture. They are made like the raised silver XP that came on the...
Had a little time today, so thought I would get some basic things done on the custom Member Designed saw. The first picture is all the tools...
