So, Dexter, don't make a mess of the 7900 of Bryan's on Sunday. You have no idea how much time it takes for me to get them as clean as new when...
If you have not tried a Husqvarna large mount Tech-Lite bar, get your hands on one, should actually make a great bar for the 665 and made in Norway!
Adam is a great guy, I enjoy discussing all kinds of 'frankensaws' with him on Chainsaw Repair. He is something you don't see often these days...
I had my wife check it out and all saws will be shipped UPS insured. A much better deal for everyone! Since I bought all remaining stock, I will...
Randy like EHP, is a class act, not like some others who frequent the sites to sell.
I have two new saws that I bought from Spike60 a 562 & 543 that I haven't made time to put gas in and run. Took down a couple of smaller dead...
Well, I don't have either in stock so will have to order no matter which they choose. So, I'll put both choices up.
I haven't the foggiest idea on a 65/72 running with an 'breathed on' 046 however my guess is no. I guess it depends on how Mdavlee defines 'play'.
Husqvarna actually has a full wrap for the 562XP. Expensive, over $100 little bugger and UGLY!
My vote is for a 365 special! I REALLY like the 365SP, light, nimble and plenty of power even stock. Do you have a subject saw on hand or are you...
Good point. Husqvarna also had a few 'West Coast Edition' saws dating back to the 272 days. In fact I just went and looked in the saw storage and...
Do you guys also want to choose the top handle type half or full wrap?
IIRC the real XPWs were only made for 3-4 years, I believe starting in 2006 and going out into late 2009-early 2010. All this happened right when...
372XPWs are great saws, I've had a couple go through my shop. Lots of folks after them, unfortunately those that have them hold on to them. The...
I have a list of all of you who want one of these. I will not contact you for payment until all the saws are in my posession. Sorry, but I don't...
There is a very detailed thread on Chainsaw Repair where Randy goes through the disassembly modification and reassembly of a 461. I'll post a link...
Here are your choices for carburetor and intake tract. 1) Walbro 12-1(B) and standard filter setup, will use the standard filter cover. 2)...
Here are the choices for the top end on the custom built saw. 1) OEM 50mm standard C/P. 2) Meteor 50mm C/P Ported by TLandrum. If you choose...
Kevin, there would not have been a problem with that. Was that K top end stock or ported?
Well, voting for the top end will begin soon, stay tuned! Voting will by a poll to start Sunday July 6 and run 1 week until the following Sunday...
