For those of us who weren't able to attend, it would be nice to have some names to go with the photos. Wish it would have been closer.
A couple of reasons for the Humboldt cut. 1 - Cleaner end for logging, 2 -It encourages the trunk to slide off the front of the stump vs sliding...
To go a step further than Woody, noodle "X"s to where you have 12" sq by 17-18" long blocks when you cut them loose. Easier to handle & simple to...
I have an 18 volt Ryobi chainsaw. Tried it with the old nicad battery when I got it & was disappointed with the performance. It turned too slow &...
Lumberjack had it at the charity cut last Saturday. Excellent condition & a strong runner! :thumbs:
For me, anything over 24" diameter goes to the saw mill or gets noodled. Even with the log lift, manhandling the splits is too much work!
They look impressive, but I were to build one, I wouldn't want to take it apart.
Nope! Notice the jaw opens wide. One of the reasons for the wood spacer & rubber blocks for the jaws. With the rubber blocks only 1" tall, if...
I have a wood lined aluminum tool bos mounted to a trailer & a separate wood tray I can put in the back of a ruck or in my van to carry the saws I...
I have a couple of Ryobi 1/4" impact guns I like to use. Light, great for dis-assembly & to snug things up. Then I hand "torque".
Works real well.
Keep the door shut. :whistle:
28 years later & I still look up to her.:D
YUP! :D Actually I am only 5'10" while my wife is 6'2". I always said I was going to marry a woman I could look up to. :whistle:
"Most horizontal splitters sit lower than that. Is up on ramps or such? That is a nice height!" I goofed! What I meant to say: Most...
I wouldn't want to have to hold levers with both hands to operate it. It is a creative way to keep the cylinder/up right lower.
Most horizontal splitters sit lower than that. Is up on ramps or such? That is a nice height!
Nate, the horizontal/vertical splitters in horizontal mode are too low & you have to catch the splits or pick them back off the ground. With the...
Gee, lets tip the round at an angle & wonder why it kept being kicked out. Design wise, the wedge should not make impact until it is parallel...
There is a tread devoted to them on AS. DHT is also a sponsor on AS. Some of their splitters are sold at Menards now. Meanwhile back at the...
