Did I ever show ya'll th etractor mods?

The real tool box and draw Bar holder carrier.




The FEL counter weight.




Cititots seat safty switch mod.



Land pride Quick hitch.



Came with lift pin bushings even.




A nice bucket load of Ash, no splitting required.




Al

 

Chain saw carrier.



The little CS400 Echo is my most used saw.





J Red rides in comfort with a view, second most used saw. think the muffler gasket went on Monday. Havn't look yet.



I have one for the right side where one of the huskys will ride. Waiting for it to warm so I can stain it as well as the J Reds holder.

Coming in the spring and summer, Swaping sides of the rear tires to widen the stance, an Engine block heater so it will always start even at -16 below. Had to resort to my Ford 5000 when it was -16 below as it has a engine block heater.

Al

 

Nioce! Is The bungee cord on the 3 point hitch also an add on?

 

No that was a factory/Dealer thing as it was there when it was delivered.

Al

 

But I don't know what it is supposed to do? Can't find any thing about it in the owners manual either.
The best perk is the spare linch pins by the bungie hooks.

Al

 

Sweet setup and sweet machine to handle all of your firewood foraging needs!

 

I had got some 4 inch PCV test plugs so I could put log chains in the front loader mounting tubes.
They were to small the tubes are 4.5 inches. I think when summer comes ai will make some from treated wood.
Could also carry wedges in the tubes, but my tool box is so big I carry the wedges in it and a couple quarts of bar/chain oil.

That big round hole by the step.



Have an Idea for that 2.5 inch hole near the loader bucket, like wrenches in a cut away PCV tube.

Al