No Longer Available 36" Tsumura Bar + 3 Milling Chains

I bought these new last October to use as a large milling setup for my 661. The last time I ran it was a couple weeks ago playing "dueling chainsaw mills" in the Black Walnut at my sister's house. After doing a side by side comparison with 36" bars on both saws, I decided I'm going to use the 880 if I ever need a 36" bar.

I'd like to get $200 shipped for all, but I'm willing to separate.

• 36" Tsumura Light and Tough, 3003 med Stihl mount, 3/8 .063 - $125 shipped
• 3 milling chains, 2 Oregon, 1 Stihl; 3/8 .063 115DL; full chisel, skip sequence, ground to 10 degrees for milling. Chains will be cleaned and sharpened prior to shipment unless buyer says otherwisde - $75 shipped

 

Nice bar. I wish I had some spare scratch.

Are you still using the 50" Cannon?

 

Thanks! I actually ended up selling the cannon to an AS member. I considered modding it to fit the 880, but while I was waiting for some help from a machinist buddy, I found a buyer. Gave him the same deal you gave me and he was quite pleased. I ended up getting a 60" GB from Left Coast.

 

Cool.

That Tsumura would look good on my 395XP, or even my 288XP.

 

Price Drop!! $175 shipped for all!

 

Shawn you know I'm green in this department. Will that fit my 066? If so, I think it should find its way to the gtg.

 

Yes. It is the equivalent of Stihl 3003/ Oregon D025.

 

Will do!

 

Chains have been cleaned, sharpened, and boxed up. Heading for a GTG in Michigan Saturday!