What projects are on your bench?

Installed one of the aftermarket hultz tanks. Worked great!

 

Add the stickers and it would look good.

 

Looks great, let us know the long term durability of those parts. I have a 361 that was dropped off a truck at 55mph and someone ran over the crank case. crank, p/c, tank and top covers are all good. I need a case, thought about parting it out. saw had less than 10 hours on it.

 

Tre fifty, scored the cylinder, found intake impulse nipple melted, flywheel side transfer cover leaking.

 

Small muffler mod.

 

whats the red stuff on the solder? copper never seize?

 

Ouch

 

Oh really,we need to talk!

 

no, I need a case... its been in the project storage section for awhile. lol

 

I put some grease on the piston to hold the lead in place. I like checking 4 corners at a time.

 

I' check three or four. when I do 3 I bend it in a triange the diameter of the piston, or four corners. amazing before you cut them how unsquare some are.

 

It's not mine! Couldn't buy it either.

 

This saw was 5 to 7 thousands off stock, I took alittle over 20 thousands off the base, I've had this bite me before in the past. The stuff grows and moves at operating temperature..........

 

Make you a brace for that muffler or get one from a 346 so that thing won't work loose and melt the oil tank.

 

that is very correct. I paid good money for a decked/cut/domed/ported 375K topend long before the 372xpw was out. on 93 it would detonate. I ran it with 50/50 of 93 and C110. tore it down and it was .009 cold... pits all over the piston and had I ran it for a long time it would have melted down for sure.

when I do the triangle, its a rounded triangle so it doesn't catch the edge on any ports. uses a lot of solder though.

 

I've read that, but of the three of four I've had here, none of the mufflers were loose. I might redo this muffler, I just made some slots to let it breath better. I'll see what I can find one for. Thanks.