Storing Saws Vertically

Pull the vent and look down the hole should be a small orange or black rubber piece. It seams to fall apart pretty quick these days .

 

I'll do that.

 

I did not see anything.

 

036 tank , I think it should be the same. Is this what you see.
There should be a rubber duck bill piece that goes in this hole.

 

Why do you have so many chainsaws ?

 

Why does a golfer need so many clubs?

One for every situation , and I have CAD

 

Thanks for the picture. The vent on my 034 and 024 are like what Mastermech describes. I was going to get a picture of one of them but I forgot to. I'll grab one tomorrow.

 

Here is the vent setup on the 034

 

You still should have the valve in the tank . #17 or #18 depending on the tank

 

I didn't see anything in mine. I'll have to run be the dealer sometime and order the valve.

 

I finally got the flap valve at the dealer yesterday. I can turn both saws upside down and they don't leak gas. Thanks for your help.

If anyone else has a 024 or 034 (i think this part fits many saws) that leaks gas out the vent here is the part number for the style vent my saw have and what it looks like.



To put the flap valve in drain the gas and turn the saw upside down and you can reach in and press it in place.

 

Is this a real question for guys on this forum??? Cheers!

 

I have had two saws leak from the vent - Husq 50 and 51 - new vent on the 50 and no leak, just got my new vent today - will put that in this pm. Cheers!