Whoops...

How many scrawny 150# are available regardless of fingers

 

It keeps getting better. Metal shavings in the gear oil.

 

Is that by chance the original oil? If it wasn't flushed out it could be the remnants of the teeth bedding in. Sometimes cost cutting leaves the gears to finish machining themselves.

 

The shavings might not mean bad news.

 

Yep, I got the front wheel a bit dirty...
Found a deep stump hole from a previous pine tree while trying to get this one pushed around...
Got that section cut and removed
The John Deere and using the loader got me out

 

Gotta watch out for them holes!

 

I take it that using the down pressure of the loader wasn't enough to put the rear tires back on the ground and back (or push) youself outta there?

 

At the angle and as soft as the dirt was, I didn't try. My friend was there with his JD, so we just hooked up a chain.

 

Well, you don't know how many times we've had to put parts back on the JD for him...
I sent him this awhile back...

 

OK now….that’s just plain mean

 

Is it just me, or does that critter on the t-shirt look like a whitetail cow?

 

I think it's an AI deer!

 

She's a chunky thing, whatever she is!

 

Here we go again.......... green vs orange....my PTO shaft is bigger than yours......bla,bla bla.

 

My bobcat must be a girl then, because it doesn’t have a pto shaft… but I could put one on it!