2 Tanks run through the ms362cm this evening

That's what the little saws are for.

 

Sounds good to me

 

LOL! But it does lower weight and have the torque needed through anything.

 

Leave the 7 pin on it with a 25" like its intended for

 

I wish there was a 12 inch 9 pin combo just for giggles. That would be something to try.

 

4" grinder makes that no prob..........and some really rotten wood

 

Mine runs a 28" full comp pretty good fer stock..

 

I have a 9 pin and usually run it with a 16" or 20". I'm about done with 16" stuff since I have to pull the spikes off the saws to be able to get through a 12x12". I've been meaning to get a 10 pin for the 088.

 

2 more tanks Saturday about 5 more she should be breaking in Right?

 

I think that's true. I'd take it easy during the first 5 or so.

 

I may have not done that you thin im ok ? I have run it like I stold it Guess I need to light up for a few more tanks

 

I run them normally but don't do any long cuts with it on the first couple tanks. After that use them like you will the rest of the time.

 

4 tanks gone through it now. What would you do guess its to late lol

 

Griz dont worry too much. Just dont go trying g to buck up 40" white oak

 

Its like filling my truck up

 

White oak was what I cut the first 2 tanks on. Seemed like it feel through it about 2 inches doey in the middle though

 

3rd tank I was cutting a tellow birtch that the 20' bar just barely made it through hard as a rock been cut down about three months

 

As long as you were not cutting something that you need the whole bar to get through from both sides and your not using a dull chain causing excess strain on the saw I would not worry too much.

If you have the CAD as bad as Dexter your gonna sell that saw next week anyway

 

I think your doing fine grizz.