same napoleon in my sig, I don't have smoke rollout issues with it but it's a straight run.
blacksmith thank you for the pictures! looks wonderful. Forgot the important part, how is the smoke when reloading?
I do like menards but I'm pretty sure what I have currently is not selkirk. I have to double check but I'm pretty sure it is the dura brand. It...
Here is what I think is most effed up. They want to regulate vehicles, but they do absolutely nothing to the largest contributor of pollution....
I can see them being a pita, like you said KISS and I'm definitely a fan of it. I believe it is just the wall support, and yea they are spendy. I...
They will do the same thing contractors do on job sites. They will carry multiple batteries and chargers and will have batteries charging all the...
Well those bends make cleaning harder and I am not going up there to clean, it's going to be a ground up effort. It's a tough decision, smoke or...
This was brought up with a friend of mine while discussing the install. I don't want to add more elbows, with the wall install- there are 2 there....
Looking at the wall thimble and T support I realize I will have to cut the eave for the class A or frame out the exterior wall a bit (so T can be...
my splitter is like with oil draining all over the mount, so I bought a drainzit and problem solved. Is it a big deal to not have a drain plug?...
Yea it saves what 3 bucks in drilling a tapping it? 3.22 with the plug :makeitrain" Consumer grade shouldn't mean throwaway. and yea I know...
I think all the newer briggs engines lack a drain plug.. At least the briggs ex on the work push mower does not have one. And I agree it is truly...
you should be ok for that long. I left mine that way over a course of a winter. Meant to discharge it and forgot about it.
On my piston based rifle, I left it cocked for a while because it was said it was ok to do that. Well the seal ended up sticking to the piston...
If I was to go the jb weld route, I would use loctite retaining compound 660. I used it on a 288 with a bum bar stud and it worked very well for...
added a pic to end of my post attempting to show what it looked like with the wall/closet before I tore it all out and installed the header.
Finally making some progress on this house from 1903. - not my primary residence Figured I'd share the journey, tried to keep most of them in...
I never heard of the rattler. hatsans are known for being a bit rough around the edges. Lots own them though so don't be shy. The .30 auto looks...
after 15 years carbon fibers tanks can have an acoustic test (modal acoustic emission)done to extend the life of the tank. Hexagon Digital Wave |...
I'm not sure slugs will perform like you expect them too. I have a nitro piston .22 (1 pump) and the FPS is specced about the same as the seneca...