Thanks. I don't know much about them yet, but I recognized it as an oddball, and it was so cheap I couldn't pass it up. Compression feels good,...
Picked up an unusual one this afternoon. [ATTACH] [ATTACH]
Yeah, it's not possible to torque down a flippy cap a little harder, the way you can with screw caps. You can make sure the O-ring is in good...
Lots available on eBay.
I measured some photos from Logrite's site, and it looks like the geometry of my hook is close enough that I can match them by reshaping the...
I have no idea where I'd get one big enough, but I suppose they might exist.
I like it. Muffler clamp!
I've bent the point up and down a bit, but it didn't make the difference I was looking for. I'd still like to vary the geometry, even if that...
Sadly mine's not adjustable.
Yes it is. Better than nothing, but not by much. If measurements confirm my suspicion I might try modifying it. There's a big (60"?) Logrite on...
Even freshly sharpened, the point of mine tends to slip over the surface of a log unless I hammer it into the bark with something. I think the...
I have a cheap cant hook that I'm not happy with. It might be the Northern Tool product, but I got it secondhand and it's not labeled so I'm not...
Either end of that range would be a good deal for sure.
It's been a good week for acquiring milling equipment. I've been hunting awhile for a cheap 32" B&C, loathe to spend too much on something I only...
For a fairly objective reference, four new PS-510's show up in a search of completed eBay listings. The average selling price was $350, which...
Explosives.
Sold.
Sold pending funds.
I know most of the people who will see this ad are already swimming in ported saws, but I thought I'd check here before putting this entirely...