If this saw was on a dealers shelf up here . I would probably buy it. An Arctic R model. Whoever the Stihl dumbass is that made it policy to NOT sell Arctic saws in the U.S. SHOULD HAVE HIS HANDS FROZE then kicked in the n--ts . REPEATEDLY !!!! Gotta go to Canada to get an intelligent saw . H.F.S. is that!!!
Found some for a hundred bucks, talked until blue in the face, to no avail. Just wants a better work saw...
Oh. Customer saw. I've done one. It ran as good as a stock 346. I've heard that you need to raise the lower transfer wall a lot and it'll run better. I didn't
T4Mike helped me lay out port timing on my 2150 cyl. After grinding I’d say it’d spank a stock 346. Runs good for what it is.
No idea. Guy said it was scored, which has never been a problem cleaning them up. pizzed me off when i tore it down and saw it like that
About ready for bed out this way. Shot of fireball and I'll be ready. Going to go use saws tomorrow a little I believe.