In loving memory of Kenis D. Keathley 6/4/81 - 3/27/22 Loving father, husband, brother, friend and firewood hoarder Rest in peace, Dexterday

2.1 cubic foot stove

Discussion in 'Modern EPA Stoves and Fireplaces' started by Huntindog1, Jan 30, 2014.

  1. Huntindog1

    Huntindog1

    Joined:
    Dec 9, 2013
    Messages:
    570
    Likes Received:
    1,186
    Location:
    South Central Indiana
    Once the thermal mass of my home got cold as in a couple times the stove burned out early before I got home which happens to everyone once in a while, then try to reverse the thermal mass of your home being cold while its Zero out side and minus wind chills. I got a good experience trying to heat the house back up, one night from 4pm to 11pm I reloaded the stove 3 times and each time letting the stove burn at really high temps. I was splitting my splits down small to get the stove to burn hotter. But it also burned faster. I think I only got the house back up to 66 deg but I like it at 70. Or should I say the wife likes it at 70, I was perfectly fine with 66.
     
    Certified106, Chvymn99 and Oldhippie like this.
  2. Chvymn99

    Chvymn99 Moderator

    Joined:
    Oct 4, 2013
    Messages:
    21,473
    Likes Received:
    113,700
    Location:
    KC Metro
    I just upgraded in December from a 1.8 to the 3.0... It was the best maneuver that I could have made. The NC30 is a beast. I was routinely pushing my NC13 to heat my house and coaling up. Cleaning out ashes and coals like everyday to every other day in cold streaks. Now I can just her purr at 550 to 600 degrees. Plus clean out ashes maybe 1 1/2 to 2 weeks.
     
    papadave likes this.
  3. Certified106

    Certified106

    Joined:
    Oct 17, 2013
    Messages:
    4,172
    Likes Received:
    11,912
    Location:
    In The Hills
    Been there done that........ Came downstairs to my door standing wide open at -11 outside..... My first floor was 35 degrees
     
    Huntindog1 likes this.
  4. Huntindog1

    Huntindog1

    Joined:
    Dec 9, 2013
    Messages:
    570
    Likes Received:
    1,186
    Location:
    South Central Indiana
    Yes that refreshes my memory on the NC30, one that people dont talk about the nc30 has a deep bottom for lots of coals. Dont have to empty it very often. Plus another aspect is you can load east west or north south an option I would like to have.
     
    Chvymn99 likes this.
  5. papadave

    papadave

    Joined:
    Oct 3, 2013
    Messages:
    18,181
    Likes Received:
    82,470
    Location:
    Right where I want to be.
    Having a stove that keeps the house comfortable in "normal" temps is great, but when you need heat.........well, you need heat.
    I say get the stove needed for abby-normal cold, then burn it with less wood or lower air settings when needed.
    If you have a leaky house and don't have plans to seal and insulate, this is even more important.
    Chvymn99, so you're saying you can control the NC30 to run @ 500-600 on a regular basis?
     
    Chvymn99 likes this.
  6. Chvymn99

    Chvymn99 Moderator

    Joined:
    Oct 4, 2013
    Messages:
    21,473
    Likes Received:
    113,700
    Location:
    KC Metro
    Yes, it's usually runs around the 550 to 600. If it's gets beyond 650. It almost heats is out of the living room. So I try to settle it sound 550 to 600. Then burn out the coals at the end of the cycle. That are at the back of the stove.

    I also keep the fan on low. That helps tremendously to spread the heat.
     
  7. Chvymn99

    Chvymn99 Moderator

    Joined:
    Oct 4, 2013
    Messages:
    21,473
    Likes Received:
    113,700
    Location:
    KC Metro
    Yes, the deep bottom helps to keep the ashes and coals in check. There was only one time where I couldn't keep up in the house that's when we dropped below zero for over 72 hrs. So I'm really happy with it. Because we don't do that very often.