Jonsered 920

I'll go measure a 288 seal in just a minute. Sharpening a kitchen knife now.

 

288 is different sized. Spike would know if a husky one crosses over for sure.

 

I checked he hasn't been on AS since Wed.. I am in no rush just having a good time.

I found this one,

15X30X7.5TC, TCM Oil Seal, Double Lip, 15 mm ID X 30 mm OD X 7.5 mm Wide, Nitrile Material

Which looks correct, and is a US made german owned company.

 

I just call him usually when his store is open.

That looks right. I have the 920 here I need to clean the cylinder up and assemble. Be my big saw for a little bit.

 

I just got orings and seals for a 920 from a husky dealer 288 seals and orings fit

I found homelite thin rings to fit the one I'm doing and I got case gasket its hell to find bearings crank I got to split case and replace all for a guy ! took 6 to 7 months to find all the parts !

good luck

 

Up and running.



With base gasket delete. .025 squish.

 

Also the link to the seal I posted is right and looks to be a good product for these saws. $6 plus shipping for two.

 

Give you $100 for it!

 

And I'll give $3k for that International rollback.

 

If we both triple our offers it would be a deal?

Any interest in an IH with a 16' Omaha dumping grain/cattle bed?

 

You got me in the haggle department Gary I'll give you that.

Don't need one.

 

Guido Salvage

Didn't you post a picture of that truck once? Seems I remember seeing orbit can not find in search.

 

My rollback or the grain truck?

 

Yes.

 

A few of the rollback truck in action...













This is the only one I can find of the '72 grain truck.

 

Back on topic, Jonsereds 910.

 

Is the 910 a runner Guido Salvage ?

 

It was, I rebuilt the carb about 5 years ago and have not run it since.

 

Looks Just like the dash of my 68.

 

The dash on those old Binders was pretty elaborate, weren't they?