Saw shootout/ MS 440, ported MS 460, MS 461, and Solo 681

Don't even need wedges when using a MS661.

The trees all just jump off the stump when they see it.

 

fixed

 

I've been known to build a mean 9010.......

Just saying.

 

That happens after they see the Mastermind sticker.

 

That was a tree monkey 390 that beat the whole field. The 372 just beat over half.

 

I knew it was a damm Husky.

That is all.

 

So the best 660 or 066 was faster than that 372?

 

Yes but not by much. If I remember right the winner was in the 24 second range and the 372 was 29. The top 6 or 8 066 were all close and then there was 8-10 slower than a 372. I think the 390 was 22 or faster

 

The top three 066s were pretty close.

My old ratty aftermarket jugged one was over a second faster that any other though.

I was right proud of that saw.

 

I'll dig for results here shortly. The videos are on cowboy 64 youtube channel

 

The Copsey crew made about 20 cuts trying to best my time......it was fun to watch.

 

Any 460/461 lurkin around that day??

 

Does the 390 have torque and speed? Im more interested in torque than a sec or so

 

I wonder if Chad's had a ported 390xp on his dyno? That would tell you torque numbers compared to a 660.

 

The 6 cube race results were interesting I thought...
That 395 of yours was a dandy..
There were a couple 066/660's in that one.. I think they were pretty low down the standings...

 

That was something. The 395 was the winner then 064 and 385.

 

They were pidling themselves in the back of the truck...

 

Been a while since I watched the vid, but I do remember the 395. Looked like Randy couldn't push hard enough. Feet almost come off the ground

 

hooray 7900

 

3120 wasn't much faster than the 395.