In loving memory of Kenis D. Keathley 6/4/81 - 3/27/22 Loving father, husband, brother, friend and firewood hoarder Rest in peace, Dexterday

What's on your bench now?

Discussion in 'Chainsaws and Power Equipment' started by Czed, Jun 29, 2020.

  1. Erik B

    Erik B

    Joined:
    May 12, 2015
    Messages:
    5,699
    Likes Received:
    39,442
    Location:
    Western Wisconsin
    That was the first saw I had. No chain break and I had no knowledge of saws. I traded it in on a used Stihl 029 super when the homelite developed a bad fuel line.
     
    Hoosier_Sam likes this.
  2. Hoosier_Sam

    Hoosier_Sam

    Joined:
    Sep 20, 2026
    Messages:
    9
    Likes Received:
    61
    Location:
    Noblesville Indiana
    Yeah it runs, but it'll load up at idle, or lean out at idle whenever it wants. Depends which way the diaphragm gets stuck I'm thinking. Never had the carb off this saw, just set and cleaned the points, pulled the rope a few times and BOOM, we had a runner (ish)
     
    Erik B likes this.
  3. Hoosier_Sam

    Hoosier_Sam

    Joined:
    Sep 20, 2026
    Messages:
    9
    Likes Received:
    61
    Location:
    Noblesville Indiana
    Welp, didn't do much after work today. But I did find a second to plop a new spark plug in my 038. That's the extent of my saw work this evening. Looking forward to this homelite Saturday morning
     
  4. Eric Wanderweg

    Eric Wanderweg

    Joined:
    Apr 10, 2020
    Messages:
    8,726
    Likes Received:
    69,345
    Location:
    Bristol, Connecticut
    This bar oil cap has been driving me nuts for almost a year and a half now. The 1/32” breather hole I drilled through it worked, but it let a considerable amount of bar oil out of it. Storing the saw with a full tank meant leakage until the level went down. I tried adding a wad of foam air filter material behind the cap but that didn’t completely stop the mess. I finally smartened up when I came across these hydraulic breather plugs this week. This should work. It better because you still can’t find a replacement cap for this first generation 200 series.
    IMG_6788.jpeg IMG_6789.jpeg
     
  5. Eric Wanderweg

    Eric Wanderweg

    Joined:
    Apr 10, 2020
    Messages:
    8,726
    Likes Received:
    69,345
    Location:
    Bristol, Connecticut
    buZZsaw BRAD I used the same hydraulic breather plug on your MS250C this morning. It was a 2 birds with 1 stone kind of fix.
     
    buZZsaw BRAD likes this.
  6. buZZsaw BRAD

    buZZsaw BRAD

    Joined:
    Feb 14, 2019
    Messages:
    35,207
    Likes Received:
    218,015
    Location:
    North Haven, Connecticut
    Cool! Ill bet it looks like a professional job! :D
     
    Eric Wanderweg likes this.