The thermostat knob on my BK Ashford is a little creaky when turning it. Are there any videos of removing the back cover and what to lube to solve the issue?
This is a semi annual maintenance task. I've done it lots of times but no videos or pictures. It's very self explanatory and hard to mess up, like a one banana job. The only important thing is that you turn the knob to full cold to close the throttle blade before reinstalling the back cover. That smooth turning knob is a delight.
Thank you for the reply. Just curious, if I have the knob set to 6:00 and take the back cover off, wouldnt the cover go back on correctly with the knob in the same position?
No. There is a maximum throttle blade stopper in the cover. It's that upper screw. At wide open throttle, say 6 o'clock position of the knob, the throttle blade should be pushing up against that stopper and when you remove the cover the throttle blade will go a little farther so that when you replace the cover the throttle blade will now be stuck on the wrong side of the stopper and won't be able to close. This causes a run away fire just like a stuck throttle on a carburetor. So if you can't turn the knob to max cold setting and verify that the throttle blade is fully closed in the horizontal position during cover reinstallation then you should not attempt this job. One last thing since it seems important. Do not unscrew anything except the two square drive cover screws. Once under the cover the spring washer is held in place with a set screw. Don't loosen that, just glob lube on there and work it in. The first time you remove the cover it might feel stuck in place. That is due to some spooge of silicone from the actual thermostat assembly. Just work it off and don't worry about reapplying any sealant, it's just sloppy assembly at the factory.