It’s time

Wow message scrambled but you get the point!

 

You'll be ready to go. My fire has been lit, and the stove won't go cold until end of May. Think we'll have a cold winter.

 

Hoping for cold and lots of snow!

 

Margaritas did it...

 

That's a nice job yall got done. Glad the young helpers pitched in. Looks good in the basement. Pallets were a great idea when the hose was loose.
Are you gonna burn the bark?
Must gonna be a cold winter in GA, we saw a GDOT dump truck with snow plow on front roll through town the other day, had spreader on back too...

 

Thanks! Yes sir I’ll shovel the bark in a little at a time.

was that the only plow they have?

 

Probably...maybe taking it to Atlanta.

 

Got stove cleaned and wood laid, ready to strike a light. Usually end of October for us

 

Same here, I'm not too far from you about 30 minutes south of Atlanta. I'm hoping for some cooler weather soon.
Shouldn't you be in bed I work nights so that's my excuse.

 

I'm on nights this weekend...days next weekend
Are you around McDonough, Griffin area? It would be nice to meet you sometime

 

I’ll hold off as long as I can here, still gotta get up on the roof and poke the chimney out. Hopefully later on this week.

 

I'm a little further west, Newnan actually. I worked in Griffin almost 16 years running 911 on the ambulance. Lots of interesting people in that city.
A few weeks ago we took a patient to a Savannah hospital and I was thinking of the area where you live. Lots of pretty country in our state.
A meeting would be nice

 

Yep, a good bit west...lol...been thru there many times on our way to a friend's house in Mentone, ALA.
We got our grapple from West GA Equipment in Tallapoosa.
We live about 50 miles east of Macon, between Macon and Augusta.

 

Got the garage heater set up for winter service.

 

Also fired up the EU300o and the EB200o. Fresh fuel and put a load on them for half hour.

 

This guy needs some love. I think the valves need adjusting and the carb could use a bath in the ultrasonic cleaner. It will be nice to be able to plug right into the transfer switch.

 

If the weather cooperates I’ll clamer up on the roof tomorrow.

 

Unless someone has been screwing around with the valve adjustment, those don't often go out of adjustment...if its been sitting, then I'm sure you are right about the carb though...

 

These things have tons of hours. I see plenty of valve seal issues. Tons of hours!