Chain Locker

While browsing FBM for saws i found this.

Chain Locker™ - Chainsaw Chain Storage Case
Looks like it'll work good but i cant fit one in my toolbox. Reminds me of the one Sirchopsalot built for his chains

 

Chain lockers made with hvbw, or tiger striped maple would be nice.

 

If it’s the one we’ve seen before, it only holds up to 20”?

 

This was the previous thread:

Chainlocker chain case

 

I dont go to this section of the forum that often so i couldve easily missed it.

 

Great idea.

It would feel like an eternity trying to get those wing nuts off......at least for me. I can't stand over-length threads.

 

Drill a small hole in the threaded end of the bolt.
Install washer , followed by a compression spring then use a small hair-pin style clip to hold it all together.

 

Its nicer when there are more chains on there.
I did however, cut one down a bit....i don't unscrew both, just one, andnthat itls the one I shortened a little.
If I had a way to make the nuts bigger, or go with heavier lag screws, they would be easier to manipulate with gloves on.
Sca