Jeez.....can't pass it up.

Looks like you did a total rebuild...
Nice job.

 

Sure is a spunky little chit. Runs great, running 12,400 rpm now. Tried a bunch of times to post a pic of it cutting but I'm trapped with the endless "error, refresh page and try again and again and again and again until your blue in the face " message.

 

Great deal for $20. How much were all the parts if you dont mind my asking?

 

Thanks Jeff. Pretty much except I didn't pull the cylinder or crack the case. I did scope it inside and it looks beautiful so I think the old man was telling me the truth about it only being occasionally used.

 

Have to upload the video to YouTube, then copy the link to the forum

 

Not at all. I'm in $187 total including the saw. Using all OEM stihl parts like...... crank seals, oil pump, all vibration mounts, fuel and oil caps, carb kit, fuel line, impulse line, oil lines(both), intake boot, rip cord and handle, nameplate (on recoil), needle bearing, rim sprocket, fuel and air filters, chain catcher and rubber block and a spark plug (waiting to install until my extra oil burns out). Probably some other things that I have forgotten. Some things didn't have to be replaced but would bug me as I'm a bit anal. The dog chewed start handle and gas caps for example along with the still probably fine rubber bits.

 

Video ?? Me ?? Ha I just meant cutting with one hand and taking a pic with the other.