In loving memory of Kenis D. Keathley 6/4/81 - 3/27/22 Loving father, husband, brother, friend and firewood hoarder Rest in peace, Dexterday

★★★★☆ EasyBlaze Blend Pellets (Review)

Discussion in 'Pellet Fuels' started by slvrblkk, Oct 12, 2015.

Thread Status:
Not open for further replies.
  1. slvrblkk

    slvrblkk

    Joined:
    Oct 6, 2013
    Messages:
    6,637
    Likes Received:
    29,489
    Location:
    Northampton, PA
    EasyBlaze Wood Pellets (Blend): FINAL RESULTS


    Temp Average – 260-390+

    Ash Volume – 6 ounces

    Ash Weight – 1.65 ounces

    Ash Percentage - .25%

    Fines In Bag – about ¾ cup

    Pellet Length Avg. – 1/4” - 3/4”

    Bag Weight – 40.0 lbs. (0 oz. left in hopper)

    Burn time – 14.25 hours (approx.)


    NOTES:

    Purchased from Bucks Pellets
    $269 ton
    75% SW (SYP) – 25% HW (Red/White Oak, Hickory and Poplar)
    Low ash


    I wasn’t sure what to expect with these since this is, I believe, EastBlazes first venture into producing blend pellets. Pellets are blonde in color, have a real nice softwood smell and a good sheen on them. Fines were acceptable. Ash was a medium brown color, fine and very low. Ash volume was very low but weighed in more than it looked.


    All in all these were better than I expected being a blend pellet. Burn time might seem short but I ran these on a high burn for most of the time. These seem to be a solid pellet, grab a few bags and give them a try!


    Highly Recommend!


    Disclaimer: as with everything....YOUR MILEAGE MAY VARY....the review is just my opinion of them

    IMAG0013.jpg IMAG0015.jpg IMAG0016.jpg IMAG0011.jpg IMAG0020.jpg IMAG0022.jpg
     
  2. Russell

    Russell

    Joined:
    Sep 9, 2015
    Messages:
    1,164
    Likes Received:
    5,627
    Location:
    South Coast , Massachusetts
    I just finished 2 test bags of EasyBlaze SYP low ash , high heat , nice smell and beautiful blonde color . can't wait for my 2 tons to be delivered Thurs . :D I would use their blend in a heartbeat .
     
    Last edited: Oct 13, 2015
Thread Status:
Not open for further replies.