Would this leak being up in the airwash area matter? It's above the airwash plate so there is no smoke up there to stain.
Folks. I want to replace my BK numberless cat probe meter with a new condar meter with numbers! http://www.condar.com/Catalytic_Thermometers.html...
I just don't want you to bust out a tombstone stick welder and blow a hole through that thin steel. Just seal the crack, birdpoop weld is fine.
I would expect a leaky door gasket to lead to overfire, white bricks, and very clean combustion. In other words, the opposite of what you just...
I think we can tell from the gasket that fell out that the clips are either MIA or the glass has slid down into the saddle of the lower clips and...
The NC30 door is the "right" way IMO. Nothing in the door gasket channel to disturb that gasket's seal and full access to the glass clip screws.
That secondary manifold is full of other holes. On purpose! I would burn it as is and make sure that jets of flame aren't squirting out. Then, if...
Whoa, do you even have top clips holding the glass? I see the bottom clips and see the gasket damage where the top ones should be but I can't make...
Ah, this door setup is not like the NC30. It is like my BK and I find this little feature irritating as hell. The screws that hold the clips that...
Sounds great. I like the somewhat bold color choice too.
Slide into it's proper place before snugging down those top screws. Not too tight, don't want to snap them, but tight enough that the gasket is...
Dex, you are my F'ing hero! That air wash plate on yours has melted and sagged. Mine did too! I'm not alone! Mine happened when I was watching it,...
That sounds about to be about the perfect "low as possible", overnight, and most efficient fire. I wouldn't run the flue temps any lower for fear...
450 surface temps are really hot. I first read your temperatures as negative 14 negative 20. How can it be zero at the roof?
Can't wait to hear how it works. I have a thermostatic air control on my BK and my NC30 is all manual. After watching all of these guys with wood...
I'm jealous of you guys with numbers on your cat meters. I just get active or inactive. I am considering paying for a replacement condar with the...
Actually, setting the stat at 50% should result in a burntime around 20 hours so overnight and half load remaining is what I would have guessed....
I have two of those inferno meters for my nc30. One on the stove and one on the pipe. I'm a condar meter fan.
Give it a shot. Just don't be tempted to simply bolt that boss onto the heatshield over the big hole.
I thought about one of those big blowers. What I like about my stove blower solution is that it blasts the air up through the gap between the heat...
