I like .325 on the 261 the best.......your mileage may vary. :)
It is sold.
That last one there. :D
Not me man........I don't bother those people.
You can see that it was leaking.......oil has been spitting out there.
It's tough to get these carbs on without folding that edge in. We've done it as well. Here's what it looks like after sitting around a little...
Both I reckon?
The finger port opens first, then the tip of the main.......nearest the intake, and then the other end of the main. There are three degrees...
They have used three different cylinder manufacturers over the years, so that is some of it. They have also reworked the jug to help with EPA...
Yep.......and it would create an air leak.
I'm porting a J'Red 2166......and I see this yet again. [IMG] I've done quite a few 365/372XTs, and several of these J'Reds. I've lost track of...
Yes......I was able to get the exhaust down without the intake going way too far. It should get decent fuel mileage......at least for a 660. :D
Yep.......I believe you are spot on. Something else to consider is the differences in cylinders. I've seen 6 - 8 different cylinders for the...
I'm just parroting what I've read about on the front end.
Another vid???? [media]
No sir.......no loader. The front end is considered a bit weak for loader use. The neighbor has a Ford 4600 with a loader......and we keep it...
The 2 series Husqvarna saws are all pretty special to me. Tougher than the newer saws, and a better torque range.
It was not the same saw. It was Chad's 660 that was the stock saw, and the muffler modded saw. Stihl rates the 660 at a HP rating that I believe...
We'll try to get out a decent log over the next couple of days. :)
It is a late '60s Massey Ferguson 135 Deluxe, with a Perkins 34hp diesel. I just got it a few months ago, and sadly it was never maintained very...
