Thank you fur your input md and good evenin...no I don't have one of those...wish I did...wouldn't know how to use it if I did...lol...have you...
Thank you fur your input md...I understand... It would be easier to trim the out portion of the piston than the squish band right?...so the 064...
Thank you fur your input md and good mornin...is a pop up piston one where you bevel the top of the piston so it will go further in the cylinder...
Thank fur your input Clem..yah...I do to...I was just wonderin...do you know anything about the stihl 52 mm piston bein used in a 52 mm cylinder...
Has anyone bought any parts from this site...there AM but look pretty good and seem like they have a good invatory. Prices seem good too.......
Good mornin Clem and thank you fur your input...it dose...all the research I did say...24 to 28 in. Bar...I didn't see any that said anything...
Ok...I'm goin to start another project soon and need a little input...I'm gonna build another Hong Kong saw...I read some where...I could use a...
Good mornin friends...well I got to work on my saws fur a little bit...hopefully those two are tuned ok...the 61 has a little hesitation on the...
Thank you fur your input Clem...I understand that now...lol...wish me luck...thank you...
Thank you fur your in put redfin and Clem....ok...that sounds good...I watched the video again and the guy says he is goin to run the low a little...
Thank you fur your input md...last night I was readin up on four strokin...and I down loaded a couple of videos on tunin the 2 Stoke carb. One of...
Thank you fur your input redfin...ok...thank you...
Thank you fur your input Clem...I don't know...the 61...I have know idea what was run thru it...but I did run my 3 month old saw mix thru it. I...
Thank you fur your input Clem...I don't know...the 2 372's ran fine before...the 61 ran like crap...all 3 run much better but slobber...I only...
Thank you fur your input redfin and Clem...yah...lol...it's all worn out...I did pull the ring...I had another use ring off a used L65...
Thank you fur your input Clem...yah...the ring still has a little spring to it....thank you...
Thank you fur the input Clem...yah I know about the needle and fork...I have kitted quite a few carbs...but I didn't know about the plug...what is...
Finished...husky 61.....[ATTACH][ATTACH][ATTACH]Thank you fur all the help friends...I couldn't have done thease saws with out your guidance and...
Thank you fur your input Clem and good mornin...yah it blows...hopefully some work comes along...or my season starts....next time my wife and me...
