I recently picked up a Dolmar 143 and it came with a 20” and a 25” bar. The Oregon 20” is the do33 mount which I believe is the 14mm size. The question is where do I find a 36” bar for this thing??!! I’ve been looking around online and haven’t had any luck, what do you guys think?
Oh youse guys and your talk of length.... Just get Shawn Curry down there with that redic bar on his 880 (I think it was on the 880?).... now, that’s some manly length.... Shawn- if ya don’t mind, queue up that pic of you at yer sister’s place on that big ol’ walnut, eh?
I got this one from Left Coast - 60” GB. My “normal” bar for it is a 36” Tsumura. The reduced weight bars are well worth it in that size - the difference is several pounds.
Here it is in .404 from a forum member. fordf150 Performance Outdoor Equipment & reduced weight. Performance Outdoor Equipment
Good prices! Is there a heck of a lot of difference in weight between those two? Another question.... how’s the .404 behave vs a 3/8? I’ve never ran any.
I dont have but a couple of those 14mm bars in stock, they sell so slow that i am a bit lazy on restocking when i sell out of a style so depending on what someone would order it may take a few days before it ships. the D025 bars require a tad bit of mods to oil on the dolly saws but its very easy and just takes a minute....IIRC its actually just a matter of plugging a couple holes so the oil actually flows on the bar instead of out under the clutch cover. 404 takes lots of HP but is awesome to run compared to 3/8 because it just seems to never go dull. also those 404 bars can be switched over to 3/8 with just tip swap.
Thanks for the info! Good talking to you on the phone too! I’ll get it measured up when I get a chance.
